-Separate two channel power supply
-Two transformers, four chokes
-Separate cabinet
-Separate two channel (four tubes)
-Very high end components (Blackgate, Jensen, Auricap, RMG...)
-Output delay
Not finish yet!! Last night did a very tough job, it take me 3 hours to finished the signal wiring (total 18pcs shielding wire & limited space). Let's see some photos!!
Finally SuperGG Finished!!! It's a very tough project but the reward is unmeasurable. It's sound amazing, high resolution, detail, good sound stage, good channel separation, dynamic & smooth, wide band width.... I think will improve more after burn-in! Later will share with all of you!
Because of separate two channel, it's no need to keep the 0.1uf. Just use 0.047uf paralle to the 100uf decoupling cap. It's inprove the high frequency!