cd机一边大声,一边声量很小

现在cd机一边大声,一边声量很小,请问哪里有问题,是否在op输出电容之后?谢谢!!!

請問如何檢查及維修

[quote:51dcbdda02="kin111kin"]請問如何檢查及維修[/quote]


首先要確定是否一定是CD機的問題，再一步一步查下去。
那是什麼CD機呢？

Found the similar post in R33, so assume is same person la,

As mention in R33, the headphone output is OK, therefore:

1. DAC is OK
2. I/V conversion stage is OK, if needed. (op-amp base tpically)
3. LPF stage should be OK. (op-amp base typically)
4. Headphone amp OK (op-amp base)
5. Line buffer stage (Check this la)

KKHo
93067521 (HK now)

耳筒和數碼輸出正常但RCA輸出一邊很細聲

could you mind open your CDP to take a photo and attach here, hard to point out the problem

唔該哂各位,原來OP附近粒電容鬆,補銲完有番聲,另想問新光頭條扁線唔小心整斷,唔知可否用番舊光頭條扁線(成條)銲去新光頭到?
有了這論壇對於像我這樣的新手真的很有幫助和鼓勵,遇到問題時有人幫助可以邊問邊試邊學習,希望已後多點有關DIY課程,因為我覺得香港的DIYER和國內或台灣的比較真的很少,

kik111,

that ribon cable (signal to laser head)can be buy at a lot shop, just bring your ribon cable to the shop to match.

Unless u r talking a bout the other flat cable to the motor of laser, then not easy to get in shop and can just solder it back.

tell me which brand of laser head you are using, I will mailing the cable to you.

KK.
93067521