Re: Pre-amp Chassis

Hi buddies

I am looking for someone who can help to make few (3~5 pcs.) 6061 aluminum pre-amp chassis for my up coming pre-amp project. Please advice. Thanks

回復  大麻成
Hey guy,
You may worth to try your local neighborhood, there are many side lanes conne ...
i886 發表於 2011-3-7 11:09

I prefer a chassis/enclosure maker who is willing to take small order. I think this kind of chassis/enclosure makers they have good experience to handle pre and power amp chassis with anodize and sand brush finishing.

Anyway, thank you for your inputs.

回復  大麻成
Ah, you go beyond DIY, stepping into hi-end~
i886 發表於 2011-3-7 14:28

Yes, pursuit for perfection.

Welcome back to Hong Kong~
Where were you educated?
You must be cooking something real nice!
i886 發表於 2011-3-8 09:05

I am 100% educated and a HKer. My cook is very bad but instead my soldering is very nice.

Hey guys   
I'm in mainland China, Foshan, may provide some advice and assistance to you, but to my understanding the surface to be machined to a perfect treatment, at least 6063 aluminum to the surface oxidation process  no produced obvious flaws.
Of course, if you do paint the surface, then the problem is no need to worry about.
You can email to me: anlige@foxmail.com

Professional DIYer!