首先要確定是否一定是CD機的問題，再一步一步查下去。
那是什麼CD機呢？作者: kk_ho 時間: 2007-2-13 10:22
Found the similar post in R33, so assume is same person la,
As mention in R33, the headphone output is OK, therefore:
1. DAC is OK
2. I/V conversion stage is OK, if needed. (op-amp base tpically)
3. LPF stage should be OK. (op-amp base typically)
4. Headphone amp OK (op-amp base)
5. Line buffer stage (Check this la)
KKHo
93067521 (HK now)作者: kin111kin 時間: 2007-2-13 19:21
耳筒和數碼輸出正常但RCA輸出一邊很細聲作者: kk_ho 時間: 2007-2-14 01:16
could you mind open your CDP to take a photo and attach here, hard to point out the problem作者: kin111kin 時間: 2007-2-14 01:51
唔該哂各位,原來OP附近粒電容鬆,補銲完有番聲,另想問新光頭條扁線唔小心整斷,唔知可否用番舊光頭條扁線(成條)銲去新光頭到?
有了這論壇對於像我這樣的新手真的很有幫助和鼓勵,遇到問題時有人幫助可以邊問邊試邊學習,希望已後多點有關DIY課程,因為我覺得香港的DIYER和國內或台灣的比較真的很少,作者: SSWONG 時間: 2007-2-14 09:06
kik111,
that ribon cable (signal to laser head)can be buy at a lot shop, just bring your ribon cable to the shop to match.
Unless u r talking a bout the other flat cable to the motor of laser, then not easy to get in shop and can just solder it back.作者: kk_ho 時間: 2007-2-14 15:46
tell me which brand of laser head you are using, I will mailing the cable to you.