sp-10 noise
there is noise occur when set the volumn at 1:00 position.can here noise 4 inch away from the speaker.
although it is acceptable, hope can reduce half to the orginal.
any high hand can give suggestion? thanks. 你搭棚架？ pcb only! 如果是廠機there is noise occur when set the volumn at 1:00 position.
一定無人會買.
DlY樂趣之一解决問題.
你部機有無pay學費上堂. ronaldc, you can come to our new place to check it on the next week! thanks william.
where is the new place? Ronald,
The place is my home....
just a joke
KK. Can I bring my economy $ pre amp JP 200 to compare.
:lol: http://www.hififever.com/forum/viewtopic.php?t=1092
Here, come on this Sat! Hi ronaldc, how's your sp10 now? everythingis good but noise. everythingis good but noise.
still not fixed?
what kind of noise? hum? ele. current? or ?
can you post photo here for the inside layout? ronaldc：你用什麼後級？ image 6bi 你試下飛起條水線！不過要小心D！ ronaldc兄
william己經跟你說了
ronaldc, you can come to our new place to check it on the next week!
為什麼你不去那邊,他們收了你錢一定辨好的.
不會是因為
KK-ho說
Unlike only "blowing" something.
你不好意思.
新手上堂certifiy to calling "金錢換取知識". 沒事的.我們全部人都明白那個道理.他們生意人也應該明白.一定解决得了.上堂時間不明白.那樣當然問老師,你不問他還可以問誰.
要是部功放有直流 出千万不要再用.有可能後面功放及喇叭死.
飛水線 :?::?::?:
Audionote@China ronaldc兄 ：問題解決了嗎？ will go to william's office try to fix it!(also try to improve) Hi William Sir,
Just finish my SP10, but I got similar problem.
Can here noise (See ... See / Dee...Dee) around 4 inch away from the speaker.
Setting:
-SP10 + UcD180
-volumn position at 0
-without input source
Is this normal?
thanks,
Kenny 點解上了堂還會這樣.
你地上堂時有沒有聽老師講解每一部份作用為什麽要這樣.每一粒零件作用改變數值後會那麼.焊上前有沒有測試每粒誤差、配對、保證工作正常.
完成有沒有用驗測電壓電流.再用毫伏表.示波器.信號發生器.失真器.頻率特性器.頻譜分析器驗測.最後用耳朵.這麼是正確基楚DlY要求.
DlY 不代表段估.
頁:
[1]